plastic for lighting and decoration
Keywords: Acrylic textured sheet, Acrylic diffuser, Thermoforming plastic/acrylic, UGR Diffuser
Home About Us Product Typical Applications News Request Sample Contact Us Blog
Products
News
Contact Us

Prism Cone Acrylic Diffuser Sheet

Prism Cone Acrylic Diffuser Sheet

    1. Prism Cone UGR diffuser with Concave hexagon,cone bottom,takes on homogeneous look due to unidirectional structure;

    2. Scientific designed structure,well defined lamp direction with average beam angle 85 degree,assist to improve the light efficiency and reasonable glare suppression;

    3. Homogeneous glare reduction in all C-levels,excellent  for workstations required lighting application UGR<19,for example LED Panel light;

    4. On equal conditions, the light transmittance is obvious higher than traditional matte or orange peel texture diffusion sheet, at the same time effectively suppress the glare value.



    Dimension(L*W*T)
    LengthwidthThickness
    1200mm1200mm1.5mm
    PatternConcave hexagon,cone bottom
    Note: according to customer demand for different mold, build the required size

    Temperature range:

    A.storage temperature:25℃±10。

    B.Long term use environment temperature:0~80℃

    C.relative air humidity:45%~75%。


    ItemTest MethodUnitPMMA
    transmission rateTransmissometer%92%
    HazeTransmissometer%80%
    water adsorptionASTM D570-98%0.3
    distortion temperatureASTM D648-0788
    vicat softening temperatureASTM D1525-09104
    linear expansivityASTMD696cm/cm/℃*10-57.6
    Thermal conductivityASTMD177Cal/cm*sec℃*10-44.5
    HRRASTM D785-08-123
    flammabilityUL 94-1996
    flammability
    UGRUGR
    ≤19

    Product Ingredient:PMMA, PE protection film


    Scientific designed structure,well defined lamp direction with average beam angle 90 degree,assist to improve the light efficiency and reasonable glare suppression;

    excellent  for workstations required lighting application UGR<19,for example LED Panel light;

    Attention:

    In conjunction with diffusion film and light guide plate,Prism Cone diffuser positioned in outer layer with the texture facing away from the led or lamp;diffusion film located in the middle layer with the microstructure facing away from the led or lamp also; the light guide plate placed on the bottom layer with the texture side placed contrary to prisma cone and diffusion film.


J.K OPTICAL PLASTIC Co., LTD.
Tel: +86 760 8986 6466 Fax: +86 760 8986 6467 E-mail: info@chinaacrylicsheet.com quetplastic@aliyun.com
Marketing Office.: LED Trading Center, Shuncheng Industry Zone, Guzhen Town, Zhongshan City, Guangdong Province
Home | About Us | Product | Typical Applications | News | Request Sample | Contact Us | Blog | Sitemap
Copyright J.K OPTICAL PLASTIC CO., LTD. All rights reserved Technical support: Reanod